Beltronics Express 926 Instrucciones de operaciones descargar pdf (Pagina 13)

Power Jack

Your

BEL detector operates on 13.8 volts DC and receives power

from the cigarette lighter socket. The cigarette lighter plug has

been designed to fit universally in all sockets. The lighter

socket must be clean and well grounded for proper operation.

Fuse Replacement

If your unit is not operating because the fuse has blown,

replace the fuse as follows:

1. Carefully unscrew the tip of the cigarette lighter plug.

2. Remove the tip from the cigarette lighter plug, followed by the

old fuse.

Note--the tip is in two pieces. Be careful not to lose either piece

or the spring inside the holder.

3. Replace the fuse with a 1-amp, 3

AG fuse. (See Accessories,

page 23, for proper replacement.) Defeating the fuse protection

can damage your unit or your vehicle's electrical system and

will void your warranty.

4. Press the tip of the plug into the body, and screw back into place.

Three Radar Frequencies

Three microwave frequencies have been allocated by the

FCC

(Federal Communications Commission) and are used for

traffic Radar: X, K and Super Wideband Ka. Your

EXPRESS

detector provides detection of all known radar traffic devices.

Total Tracking Laser

™

(TTL

™

)

Unlike Radar signals, which are highly reflective, Laser signals

have very poor reflective characteristics. Many of today's Laser

detectors do not have the high sensitivity necessary to detect

UNDERSTANDING RADAR, LASER AND SWS

™

10163_916-926 Op. Manual.FINAL 5/2/02 1:26 PM Page 13 R

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Beltronics Express 926 Instrucciones de operaciones Pagina 13